Skip to content
Home Improvement

Electric Water Heater Installation: What Homeowners Should Know

Updated 8 min read

Upgrading to a new electric water heater? Learn about electrical requirements, tank vs. tankless options, and what professional installation involves.

Written by the licensed electricians at First Choice ElectricMO License #2025001688

Water heaters are the second-largest energy users in most homes, after HVAC. When it's time for replacement, understanding your options and electrical requirements helps you make the right choice.

Electric vs. Gas Water Heaters

Electric Water Heaters

Advantages:

  • Lower upfront cost
  • No venting required
  • No gas line needed
  • Slightly more efficient (no standby combustion losses)
  • Can be installed in more locations
  • Safer (no combustion)

Disadvantages:

  • Higher operating cost (electricity costs more than gas in most areas)
  • Slower recovery time (reheating after use)

When Electric Makes Sense

  • No existing gas line to water heater location
  • Cost to run gas line is prohibitive
  • Heat pump water heater is an option
  • Solar or other renewable electricity source

Tank vs. Tankless Electric

Tank Water Heaters

How they work: Heat and store 40-80 gallons continuously

Pros:

  • Lower initial cost
  • Simpler installation
  • Supplies multiple fixtures simultaneously
  • Works with existing electrical in most cases

Cons:

  • Higher energy use (standby losses)
  • Runs out during heavy use
  • Takes up floor space
  • 10-15 year lifespan

Tankless Water Heaters

How they work: Heat water on demand as it flows through

Pros:

  • Never runs out of hot water
  • Lower energy use (no standby losses)
  • Wall-mounted (saves floor space)
  • 20+ year lifespan

Cons:

  • Higher initial cost
  • Often requires electrical upgrade
  • May struggle with simultaneous high demand
  • More complex installation

Heat Pump Water Heaters

How they work: Use heat pump technology to heat water (like AC in reverse)

Pros:

  • 2-3x more efficient than standard electric
  • Lower operating costs
  • May qualify for Ameren Missouri efficiency programs; the federal credit ended after 2025
  • Slight dehumidification bonus

Cons:

  • Higher initial cost
  • Needs space around unit (for air circulation)
  • Cooler ambient air exhaust
  • Slower recovery than standard electric

Electrical work for St. Charles & St. Louis County homes

Free on-site estimate, flat price before any work starts.

Electrical Requirements

Standard Tank Water Heater (40-50 gallon)

  • Voltage: 240V
  • Amperage: Usually 18-25A
  • Breaker: 30A double-pole
  • Wire: 10/2 copper
  • Dedicated circuit: Yes

Large Tank Water Heater (66-80 gallon)

  • May require up to 4500W elements
  • Possibly larger circuit needed

Tankless Electric Water Heater

This is where it gets interesting:

  • Whole-house units: 100-150+ amps total
  • Often require 3-4 dedicated 40-50A circuits
  • May require panel upgrade
  • Not always practical without major electrical work

Heat Pump Water Heater

  • Similar to standard tank (30A circuit typical)
  • Needs clearance around unit for air flow
  • 240V dedicated circuit

Replacing an Existing Electric Water Heater

If you're replacing an existing electric water heater with a similar unit:

  • Existing circuit usually works
  • Verify wire condition
  • Check breaker condition
  • May need disconnect/reconnect only

Installing New Electric Water Heater

If switching from gas to electric or new construction:

  • New 240V circuit from panel
  • Proper wire sizing for distance
  • Permit required in most jurisdictions
  • Panel capacity verification

The Installation Process

Tank Water Heater Replacement

  1. Turn off power at breaker
  2. Drain old water heater
  3. Disconnect plumbing and electrical
  4. Remove old unit
  5. Position new unit
  6. Connect plumbing
  7. Connect electrical (verify proper wiring)
  8. Fill and test
  9. Set temperature (120°F recommended)

For New Installations

Add:

  • Run new circuit from panel
  • Install disconnect if required
  • Permit and inspection

Common Questions

Q: Can I install a water heater myself? A: In Missouri, electrical connections should be done by licensed electricians. Plumbing too may require licensed professionals. Permits are required.

Q: How long does installation take? A: Tank replacement typically 2-3 hours. New installation with electrical work may take 4-6 hours.

Q: Should I get a bigger water heater? A: Depends on household size and usage patterns. We can help size appropriately.

Q: What temperature should I set? A: 120°F balances comfort, safety, and energy efficiency. Higher temperatures waste energy and risk scalding.

When to Call Us

We handle the electrical side of water heater installation:

  • New circuit installation
  • Panel capacity assessment
  • Proper wiring connections
  • Permit and inspection
  • Disconnect installation

We coordinate with plumbers for complete installation or work alongside your chosen plumber.

Service Areas

We service water heater electrical throughout the St. Louis metro including Chesterfield, Ballwin, Wildwood, Creve Coeur, Town and Country, Manchester, Kirkwood, Webster Groves, O'Fallon, St. Peters, St. Charles, Wentzville, Lake St. Louis, and Cottleville.

Need Water Heater Help?

Contact us for water heater electrical service, whether you're replacing an existing unit or installing new.

Tags:

#water-heater#electric-water-heater#tankless#heat-pump#st-louis

Electrical work for St. Charles & St. Louis County homes

Free on-site estimate, flat price before any work starts.

Get new posts by email

One short email when we publish. No spam, unsubscribe any time.